A fiber-optic patch cord is constructed from a core with a high, surrounded by a coating with a low refractive index, that is strengthened by and surrounded by a protective jacket. The protective aramid yarns and outer jacket minimize physical damage to the core and coating. The light is transported along the optical fiber via its smallest and most crucial component, which is called the core.
Read More
Dynamic Load Balancing (DLB) is an advanced and intelligent hashing mechanism that dynamically directs traffic over underutilized links. This occurs at the IP layer (Layer 3 in the OSI model) and is often implemented in modern networking hardware such as Nexus 9000 series switches. While application load balancers can be used to distribute load across across an array of devices for a particular application or purpose, this article will. Currently only the EX3300 connects to our WAN Router and is trunked via 4 LACP links to the HP2848.
Read More
By the mid-1990s, most network switch manufacturers had included aggregation capability as a proprietary extension to increase bandwidth between their switches. Ethernet frame in LANs or multi-link PPP in WANs, Ethernet MAC address) aggregation typically occurs across switch ports, which can be either physical ports or virtual ones managed by an operating system. An aggregation switch is a network device that consolidates traffic from multiple access switches, wireless access points, or other edge devices and forwards it to core switches or routers. It does this by splitting traffic across multiple ports instead of forcing clients to use a single uplink port on a switch.
Read More
Use the fiber stripper to cut off 2" (50mm) of the cable jacket and pull off the cut piece. Let's explain a little about common layers, and what's important to consider when stripping. This guide reveals the secrets to fusion splicing with little fluff—just proven, straightforward techniques refined from years of work in the field. The coating can readily be removed with conventional fiber stripping tools such as the Clauss CFS-1 or Fitel S-210 for fiber with a 125 μm cladding diameter or a Clauss No Nik stripper for cladding diameters larger than 125 m.
Read More
Industry standards often recommend at least 300mm (12 inches) of spacing between power and control trays to minimize EMI. Understanding cable tray spacing is key to meeting safety regulations and maintaining system performance. The spacing between trays, whether horizontal or vertical, depends on various factors like cable type, environment, and tray material. Where products of five metre lengths or above are packed in bundles, they shall be supported with a minimum of three timber bearers which provide sufficient clearance to accommodate the forks of a forklift truck. For runs at an angle of 30 Degrees or less from the vertical, the vertical spacing is applicable.
Read More+27 10 247 8396
Unit 7, Summit Place, 21 Summit Rd, Midrand, Johannesburg, 1685, South Africa