An SC/APC fiber optic adapter is a passive mechanical interface used to join two SC connectors that have angled physical contact (APC) ferrules, typically polished at 8°. To put it simply, PC, UPC, and APC refer to the polish styles of the ferrules inside the fiber optic connectors, just as the following figure shows.
Read More
100BASE-FX is a Fast Ethernet fiber optic standard defined by the IEEE under IEEE 802. It specifies 100Mbps data transmission over multimode fiber using a 1310nm wavelength and 4B/5B encoding. The MC100CM is a media converter designed to connect 100BASE-FX fiber to 100Base-TX copper and vice versa. The FS® 100BASE Small Form-Factor Pluggable (SFP) device (Figure 1) is a hot-swappable input/output device that plugs into Fast Ethernet ports, dual-rate Fast/Gigabit Ethernet ports, or Gigabit Ethernet ports of a FS switch or router, linking the port with the fiber cabling network. Extreme Networks switches and routers support SFP (small form factor pluggable) interface modules, also known as mini-GBICs.
Read More
The MPO (Multi-fiber Push On) fiber optic jumper connector is one of the MT series of connectors. This article serves as a technical and operational guide for decision-makers, providing the necessary framework to evaluate, select, and deploy MPO patch cords, avoiding common. This unique feature allows for greater density and efficiency, as well as simplified installation and maintenance. Standard MPO connectors use plastic pin retainers, which are less durable and more likely to cause pin damage.
Read More
Fiber optic adapters may be small, but their impact on network stability and signal performance is significant. These simple yet critical components ensure precise alignment between two fiber connectors, enabling efficient light transmission with minimal signal loss. Optical connectors are used to connect optical devices to other optical devices or systems.
Read More
The T020-001-LC50 FC to LC 50/125 Adapter converts a native FC fiber female port on the T020-001-PSF Multi-Function Optical Fiber Cable Tester to an LC female port for 50/125 multimode cable testing. The following article describes how to test an LC to LC fiber link using TIA/EIA Method B for Multimode and TIA/EIA Method A. Testing a fiber optic cable with LC connectors is crucial for verifying that your fiber optic network meets industry standards for performance and reliability. Find portable power meters, visual fault locators, and multi-function testing tools. OptoSpan's FIBER-TEST-LC (For LC, SC, FC, ST, E-2000 connectors) is a simple fiber optic cable tester that uses 650nm red light to pinpoint the location of any breaks and cracks in the single-mode or multimode fiber for up to 3km.
Read More+27 10 247 8396
+49 69 975 331 42
Unit 7, Summit Place, 21 Summit Rd, Midrand, Johannesburg, 1685, South Africa