The Fibre Channel physical layer is based on serial connections that use fiber optics to copper between corresponding pluggable modules. When the technology was originally devised, it ran over optical fiber cables only and, as such, was called "Fiber Channel".
Read More
Protective relays work in conjunction with various electrical protection and control devices, such as Miniature Circuit Breakers (MCBs) and Molded Case Circuit Breakers (MCCBs), to maintain system stability and prevent damage during fault conditions. Protective relays and devices have been developed over 100 years ago to provide "last line" of defense for the electrical systems. They are intended to quickly identify a fault and isolate it so the balance of the system continue to run under normal conditions.
Read More
Moving the HDD controller from the interface card to the disk drive helped to standardize the host/controller interface, reduce the programming complexity in the host device driver, and reduced system cost and complexity. Overview are accessed over one of a number of types, including (PATA, also called IDE or ; described before the introduction of SATA as ATA), (SATA),, (SAS),. (As for all early interfaces above, each drive also has an additional power cable, usually direct to the power s.
Read More
pigtails can be divided into single-mode (colored yellow) and multimode (colored orange) fiber. 5/125 micron or 50/125 micron bulk multimode fiber cables and terminated them with multimode fiber optic c. Fiber Optic Pigtails, In fiber optic cable installation, how cables are attached to the system is vital to the success of network.
Read More
The battery-side interface provides single-sided IPX7 waterproof protection, and achieves IPX5 rating after mating. Applications: FC09 floating series battery connector features a 2+5 pin configuration with a current rating of 40A–60A. Designed for high-frequency mating applications, it supports reversible insertion and delivers over 5,000 mating cycles. As a result, Molex has launched connection solutions dedicated to battery pack connectivity, helping o it (VCU), on-board charger (OBC) and others. The BMU provides real-time monitoring of the total current, total voltage, cell voltage, temperature. These ICs can support various communication protocols such as SPI, CAN FD, UART and UWB.
Read More+27 10 247 8396
Unit 7, Summit Place, 21 Summit Rd, Midrand, Johannesburg, 1685, South Africa