Yes, fiber optic cables have bandwidth limitations, but these are typically determined by terminal equipment (lasers, receivers, optical amplifiers) rather than the fiber itself.
Read More
To set up your router for fiber internet quickly, connect the router to your fiber modem, access the router's settings via a web browser, and input the provided ISP credentials. In this guide, we'll explain router compatibility, setup steps and whether upgrading your router is necessary to maximize fiber speeds.
Read More
For LOS (Loss of Signal) red lights on fiber or advanced gateways, it usually means the incoming optical line is not detected or has low signal. Double-check that the fiber line is connected properly and that there's no bend or physical damage. However, when it blinks red or stays solid red, it signifies a Loss of Signal, a problem preventing your router from communicating.
Read More
This guide dives deep into Bridge Mode ONU, explaining how this simple setting can eliminate double NAT, reduce latency, and give you full control over your network. In the settings for your Wi-Fi router, you may find an option for enabling "Bridge Mode," "Passthrough Mode," or "IP Passthrough. " Although there are small technical differences between true bridge mode and IP passthrough, which we will address in a moment, they function the same for most people. I have an optic cable that is plugged into the internet providers provided router, Huawei EchoLife HG8145V5. When Bridge Mode is enabled, which is commonly used when you have an existing upstream network, your Linksys Mesh system will see the two networks as a single entity. It's a practical way to extend coverage, reuse old hardware, and connect distant rooms or buildings to your main network.
Read More
The working principle of the wireless access point is that the network signal is transmitted through a twisted-pair cable, and after the compilation of AP products, the electrical signal is converted into a radio signal and sent out to form the wireless network coverage. q1) Can I just think of AP as "wireless L2 switch" which also bridge the radio signal network to the wired network q2) can AP work as a standalone if i just want wireless connectivity in the devices connected to it, without an uplink to any router. Access points and wireless LAN cards connect devices in a network using radio signals. Before a device can have wi-fi access, it must announce its capabilities and be granted authorization to join.
Read More+27 10 247 8396
Unit 7, Summit Place, 21 Summit Rd, Midrand, Johannesburg, 1685, South Africa